2000 R1100R rear turn signal replacement?

[sprshrp]

Hey there guys, new member here, was hoping someone might be able to help me out.

I recently lost my rear-left turn signal (the entire housing is gone, but the wiring is still there... hanging...), and was wondering if anyone had any suggestions on where to get a replacement? I checked Bob's BMW and A&S cycles, but was unable to find parts for my 2000 r1100r. I'm open to OEM or aftermarket, just want to get something installed!

Thanks for your help!

[00zero]

Well, if they do not have it, check this


http://www.maxbmwmotorcycles.com/fiche/ ... spid=47947

[philbytx]

For used (and some new) parts, try
www.beemerboneyard.com

[OU812]

For used (and some new) parts, try http://www.beemerboneyard.com
[/url]

They have lots of parts.

[sprshrp]

thanks for the help, guys!

[philbytx]

You will probably need to get the whole kit and caboodle....not cheap!
Just had to replace parts of my front turn signal. Fortunately, I found the most expensive part on the ground!

So, check out the parts you will need at this link:

http://www.webparts.com/diagram.php?btn ... g=63&fg=10


As you will see, they aren't cheap!

[roadglide]

I had a crash that destroyed two of the turn signals and to replace the stock signals cost a bloody fortune (just the lens and housing for one directional is about fifty dollars not including the stem). I replaced all four with Baja Design turn signals. These look very close to stock but are a bit smaller however when mounted on my r1100r is un-noticeable. They are dot approved and very bright when activated

https://www.bajadesigns.com/NET/P-60419 ... rd%2c+Pair

[roadglide]

Update on the Baja Turn signals. It turns out with the saddle bag rack the rears are about an inch too short the fronts look and work well. I was lucky and found a complete rear fender with stop light and directional’s. Stupid me I did not take in account the length of the studs I went on the overall length of the directional oopps