BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

I'm going to install some Motolights on the front calipers. Can anyone provide the torque values for those bolts?

Thanks.

30 Nm (newton meters) for the calipers
8 Nm for the adjustment screw

Source : Jim Von Baden's R1200 Maintenance CD.

http://www.marcparnes.com/BMW_R1200_Mai ... _Video.htm

Note however that according to MotoLights website, you want to use the bike manufacturers recommendations for the brake caliper bolts when attaching your lights. On my R1150, it is 40 Nm - don't know if it is only 30 Nm on your R1200.

Here you go:




Front brake Brake disc to front wheel M8 x 25 -10.9, Replace screw Micro-encapsulated tighten by stages in diagonally opposite sequence Initial torque, 12 Nm Final torque, 24 Nm

Brake caliper to slider tube M8 x 32 - 10.9 30 Nm

Brake fitting bleed screw M5 2 Nm Bleed screw, brake caliper, front 5 Nm

Rear brake Brake caliper, rear, to final drive M8 x 25 24 Nm

Brake disc to wheel carrier M8 x 15.5, Replace screw Micro-encapsulated 30 Nm

Brake caliper, rear, bleed screw 5 Nm

Thanks for the info!

Now if DHL delivers the lights today like they are supposed to, I'll be all set!