BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

Where do you mount your tax disk holder?

My one was dealer supplied - cheap and leaking. It was mounted to the front of the left cylinder guard and died being smashed into someones rear bumper while filtering. (no cylinders were harmed during the making of this movie , the car driver was not upset either)

Got a new one ... and so far the best place I found is to mount it on one of screws holding the front fender (Rockster, not R1150R).

I was thinking the exhaust mounting screw, but it is a difficult reach - especially with a hugger.

Suggestions are greatly appreciated!!!

From what I've seen there seems to be two places.

Rear footgeg/exhaust mount...or...front fork/brake.

If you look up all the BMW dealers in England and check out their second hand bikes you'll see a few options.

DJ

Inside bottom bolt on the rear of the LH cylinder head seems to be most common for boxers. At least, that's where I've always put mine.

I hate the tax disk holder wherever it is mounted, so I stick mine on the screen with a one-time-use holder, which takes me about 10 minutes to get off come renewal, so I figure it's gonna keep the scumbags away too.