Page 1 of 1
pinging at hi revs
Posted: Thu May 28, 2015 11:38 pm
by skylarmav1
Hey all- probaby a simple Q but after my Beakster is warmed up and I'm just riding, if I jam on the throttle and take it to higher revs, I do hear a bit of "pinging." I always run 93 oct. Is this a need for valve adj.-throttle body or what?
As always, thx for everyone's in input,
Skylarmav1
Re: pinging at hi revs
Posted: Fri May 29, 2015 4:57 am
by riceburner
Valve check (when cold) and TB balance (when hot) wouldn't hurt.
Also running some injector cleaner first probably wouldn't hurt.
I've heard good things about 'SeaFoam', but never used it. (never seen it here in the UK).
Re: pinging at hi revs
Posted: Fri May 29, 2015 11:46 pm
by skylarmav1
I actually run Seafoam in my autos and when I first bought the Beakster I'd put a bit in with each full tank. I'll go back to doing that and see what happens.
Thx.
Skylarmav
Re: pinging at hi revs
Posted: Sat May 30, 2015 9:11 am
by sjbmw
The R1150R manual calls for 89 Octane. Any time I put another octane in I get ping, surge, etc.
Try a few tanks of good quality 89 Octane see if that helps.
Seafoam every other month or so is good too.
I have found one product that makes my 42k 2004 R1150R run as well as they day I bought it.
Liquid Performance Ethanol Equalizer.
http://www.liquidperformance.com/automo ... equalizer/
One bottle treats 40 gallons of gas. A half ounce every fill up.
The smoothness of the roll on power from 4k to 7k is amazing.
As my bike got older, it got more finicky, this stuff brings it right back.
Outside of finding ethanol free gas, this stuff is great.
Re: pinging at hi revs
Posted: Sat May 30, 2015 12:18 pm
by maccraith
If that doesn't do it, I suggest you check the timing. Sounds like you may be running a little advanced.
Re: pinging at hi revs
Posted: Sat May 30, 2015 5:44 pm
by skylarmav1
Interesting. Never heard of it - I'll check it out. What kind of miles did you consider older? I have "only" 16,300 on my beakster. Thx.
Re: pinging at hi revs
Posted: Sat May 30, 2015 11:57 pm
by skylarmav1
Timing-ok, will check out.
Thx.
Posted: Sun May 31, 2015 4:50 pm
by RadicalR1150R
Deleted
Re: pinging at hi revs
Posted: Sun May 31, 2015 11:02 pm
by skylarmav1
Hmm, may have to look for some Chris Harris vids on timing. Thx Mac!
Re: pinging at hi revs
Posted: Mon Jun 01, 2015 6:48 am
by Roger 04 rt
skylarmav1 wrote:Hey all- probaby a simple Q but after my Beakster is warmed up and I'm just riding, if I jam on the throttle and take it to higher revs, I do hear a bit of "pinging." I always run 93 oct. Is this a need for valve adj.-throttle body or what?
As always, thx for everyone's in input,
Skylarmav1
If this just started happening or if it used to not ping, I think it is urgent that you check your fuel system. My bike started doing that and after a couple months a leaking fuel hose inside my tank ruptured while in the highway, bring my trip to a halt.
You can check it by measuring the volume of fuel returned back to the tank while the bike is idling. No need to measure fuel pressure. Here is a link:
http://bmwsporttouring.com/ubbthreads/u ... Post838585
Re: pinging at hi revs
Posted: Mon Jun 01, 2015 4:27 pm
by skylarmav1
Thanks Roger. It has happened occasionally for a while. I don't step hard on the throttle much so I think it may be more of gas cleansing issue. I'll try that first and very much appreciate your info for the next step if needed.