BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

Broke off my right front turn-signal stalk in a garage tip-over. Have a replacement coming but unsure on how to take off the old one and install the new.
It's part number 63132306318
on this page
http://www.ascycles.com/Illustrated_cat ... at=63_0573

Anyway, I'm unclear about how the wires slip out of the old stalk. Do I have to disassemble and unwire the turn indicator? Please forgive my ignorance, but I'm a total moron when it comes to wrenching.
Appreciate any advice

Just done both the fronts on my Rockster.

Yes, you need to completely disassemble the entire indicator. The wires are a push-fit onto the lamp shroud/reflector part. It's actually pretty easy once you get in there.