Page 1 of 1
Looking for a stock Rockster handlebar
Posted: Thu Jan 13, 2011 11:30 am
by ContraMoto
If any of you Rocksters have a spare set of the stock bars laying around, send me a message. Looking to put them on my R1200R...
Thanks!
Re: Looking for a stock Rockster handlebar
Posted: Sat Jan 22, 2011 4:42 pm
by motocyclista
Hi there, I have one ready waiting.
I took it from my bike, it is used one. I had about 5000 miles on it.
It has a tiny scratch on the center.
I can sell it to you for $80.00 plus shipping.
Re: Looking for a stock Rockster handlebar
Posted: Thu Feb 03, 2011 8:36 am
by ContraMoto
Pm sent...
Can anyone tell me how wide the Rockster bars are, from tip to tip?
And...are the ends of the bars stepped down in size to accept the bar-ends, as on later BMW bikes? (ie, the R1200R)
Re: Looking for a stock Rockster handlebar
Posted: Thu Feb 03, 2011 12:32 pm
by sweatmark
Can anyone tell me how wide the Rockster bars are, from tip to tip?
Rockster OE handlebar = 32.25" measured straight line, tip-to-tip*.
And...are the ends of the bars stepped down in size to accept the bar-ends, as on later BMW bikes? (ie, the R1200R)
No. The R1200 series (F800 also) use a handlebar end configuration different from the R1100/1150 bikes. The earlier bikes use heated grips with power wire routed through handlebar interior, requiring special bar-end mount geometry. Go to BeemerBoneyard and compare pics of handlebars and bar-ends for Oilheads versus Hexheads.
Here's the tip/end geometry for a Rockster OE handlebar:
* Handlebar width measured across bar-end mount bosses.